Canon AS-100M Field Service Manual page 53

(2) Switch setting for MAIN UNIT
© MAIN UNIT (B/W, COLOR) + 5"
(2) MAIN UNIT (B/W, COLOR) + 8 "
Unnecessary to set the switches, only confirm the swithes.
Refer to each table in paragraph (1).
(3) MAIN UNIT (B/W, COLOR) + 5"
(4) MAIN UNIT (B/W, COLOR) + 8"
In each of above system configurations, it is necessary to set
swithces located in following P.C.B.
1) 8" FDD-I/F P.C.B (C and D sides)
The switches specified In each of P.C.B, other than those above
must go through only the confirmation, for .normally.
Set following switches of SW1
switch in 8" FDD-I/F P.C.B to
specified positions.
No. 5 "OFF"
No. 6 "ON"
+
No. 7 - ► "OFF"
No. 8 - * • "ON"
4-9
FDD
FDD
FDD(A,B) + 8" FDD(C,D)
FDD(A,B) + 8" FDD(C,D)