Canon AS-100M Field Service Manual page 120

7.3.3 ^-debugger commands
The ^-debugger is built in ROM of CPU.
other than those of single step, NMI, and break point and
addresses from 400H ^ FFFFF
appropriated for ^-debugger) within system memory area are
accessibled.
I/O memory area except in DISPLAY CONT are also accessi­
ble.
(1) Command table
Commands and their meanings
B (Boot)
D (Display Memory)
G (Go)
1 (Port Input)
N (Single Step)
0 (Port Output)
R (Read Hex File)
S (Substitute Memory)
X (Examine/Modify Register)
Any of alphabetical characters within [ ]
can be omitted from designation.
Underlined alphabetic characters are debugger outputs.
Any of alphabetical characters within <
is an abbreviation.
The vector tables
(address from 350^
j j
Key operations (See abbreviations)
[< >] [ ]< >
b n d c r
D[W]<ADDR>[,<ADDR2>]<CR>
G<CS:IP><OLD>[<ADDR>[,<BRK>]]<CR>
I[W]<P0RT><CR/,>
N<CS:IP><0LD>[<ADDR>]<CR/,>
0[W]<P0RT>,<NEW><CR/,>
R[<BIAS>]<CR>
S[W]<ADDR>,<OLD>t<NEW>]<CR/,>
X<CR> X<REG><OLD>[<NEW>]<CR/,>
Table 7.3.5
7-14
3FFfl is
*\
j
>