Co2 Analyzer - Hach BioTector B7000i User Manual

8.3.10

CO2 Analyzer

ANALYSIS GRAPH SCALE
INTERFACE
BAUDRATE
CO2 ANALYZER RANGE
CO2 ANALYZER CAL
10000ppm  ANALYSIS GRAPH SCALE determines the scale of the y-axis
"CO
Screen (see Section
details). This function allows the system to display CO
peaks in optimal resolution on the LCD screen.
 The ANALYSIS GRAPH SCALE is independent of the CO2
ANALYZER RANGE described below. Note that, in certain
circumstances, when the displayed CO
exceeds the scale of the graph, the CO
measuring and integrating the CO
result, without losing any CO
RS232  INTERFACE (RS232 by default) defines whether the
communication between the CO
by analog (4-20mA) or digital (RS232) signals.
9600  BAUDRATE (9600bps by default) specifies the data
communication signaling speed of CO
INTERFACE is programmed as RS232 above.
15000ppm  CO2 ANALYZER RANGE (15000ppm by default) defines the full
scale range of the CO
 When RS232 INTERFACE is used, CO2 ANALYZER RANGE
only displays the range of the specific CO
the BioTector.
 When 4-20mA INTERFACE is used, CO2 ANALYZER RANGE
defines the full scale of the 4-20mA analog input signal coming
from the CO
 The CO2 ANALYZER CALIBRATION menu allows the user to
change the CO
span parameters when necessary.
 If the INTERFACE is RS232, the calibration range of the CO
analyzer can be changed using the CO2 ANALYZER
CALIBRATION menu directly.
 If the INTERFACE is 4-20mA, and if it is absolutely necessary to
change the CO
distributor for details of the CO
analyzer's ppm-CO readings" on the Analysis Graph
2 2
2.1.4
data.
2
analyzer installed inside the BioTector.
2
analyzer.
2
analyzer range and the CO
2
analyzer range, please contact manufacturer or
2
2
Analysis Graph Screen
2
peaks on screen
2
analyzer keeps
2
readings to obtain the TOC
2
Analyzer and the BioTector is
2
Analyzer when the
2
analyzer installed into
2
analyzer zero and
2
analyzer calibration procedures.
for
data
2
Page 134