Installing The Hopper; Installing The Hopper Handle; Preparing For The Hopper; Attaching The Grill Probe Wires - Louisiana Grills LG800 Elite Instructions And User Manual

Assembly Instruction

INSTALLING THE HOPPER

Parts Required:
1 x Series 5C Hopper Assembly
1 x Hopper Handle
8 x Multi-Head screws ( AA )
Tools Required:
Large Phillips Screwdriver or
Phillips Drive Bit and Drill
Installation:
Step 1 Installing the Hopper Handle:
The Hopper Handle is multi-purpose. Not only is used to move the unit,
but can also be used to wrap the power cord around, for easy storage.
The hopper handle also has two smaller size holes. These are used
to insert the meat probe.

Using two (2) Multi-head screws (AA) , secure the handle
to hopper access panel, just above the fan intake
through the two (2) large holes provided.

Begin by hand starting the threads, then use your
Phillips screwdriver to secure
Step 2

Preparing for the Hopper:


Place six (6) Multi-head screws (AA) into the main upper cabinet
cavity to aid in installing the hopper.
Step 3

Attaching the Grill Probe Wires:

Your Grill/Smoker comes complete with the "Digital Control Center"
complete with grill probe and programmable meat probe. The grill probe
has been factory installed in the cabinet, with the excess wire and connections
run out through the left end. Be careful not to kink or damage the wires.
The wire connections to the control board can be found inside or taped to the
Diagram C
outside of the hopper.
To connect the spade connections, carefully lift the entire hopper to the
left hand-side of the upper cooking cabinet.
IMPORTANT: Ensure the probe wires are run only through this large
hole in the hopper as shown in the diagram. Diagram C

Begin by resting the bottom of the hopper on the inside of the hopper cut .
Support the hopper on your leg as you connect the two spade connections.
Diagram D

After firmly connecting the spade connections, carefully thread
ALL excess wire, as well as the connections, back into the
hopper. The wiring must not come in contact with either the
fan blades, or the metal auger tube.
IMPORTANT: All excess wire and connections must be placed back in
the hopper. Ensure that they DO NOT touch the fan.
.
A
C
D
11
11