Software Installation - Lippert PC/104-Plus Technical Manual

Technical Manual PC/104-Plus "Cool RoadRunner II" Version 1.16 April 2004 Page 25 of 42
All changes in the setup of the BIOS are stored in the CMOS RAM of the real time clock. A
copy of the CMOS RAM excluding date and time data is stored in the flash ROM. This
means that even if the backup battery runs out of power, the CMOS settings are not lost.
Only date and time will be set to a default value of. This battery is designed to last about
ten years in use. To store the board the battery should be disconnected.
The default values of the BIOS can be automatically loaded at boot time. Therefore the
key
" 0 / INSERT " on the num pad has to be pressed before the system is turned on. While
pressing this key and turning the system on, the default values will be loaded.

2.3 Software installation

For the "Cool RoadRunner II" are software drivers for Sound, Ethernet and graphic avail-
able. These drivers are delivered on request. For installation follow the instructions on the
driver disks.
© LIPPERT Automationstechnik GmbH • Hans-Thoma-Str. 11 • 68163 Mannheim • Tel: 0621/43214-0 • Fax: 0621/43214-30