Cisco 8821 Manual page 130

HTTPS Server
Web Admin
Admin Password
Bluetooth
WLAN Profile 1 Prompt Mode
Out of Range Alert
Scan Mode
Application URL
Application Button Activation Timer
Application Button Priority
Emergency Numbers
Dialing Mode
Cisco Wireless IP Phone 8821 and 8821-EX Wireless LAN Deployment Guide
relies on web access.
This parameter specifies whether to permit HTTP and HTTPS or HTTPS only
connections if Web Access is enabled.
This parameter controls the accessibility of the Web Admin interface, which
operates independently from the Web Access parameter. If disabled, then the
Web Admin interface is not available. If enabled, then the Web Admin interface
is available, but also requires the Admin Password to be specified.
This parameter specifies the password to access the phone's Web Admin
interface. Enter a 8-127 character password.
This parameter specifies whether the phone's Bluetooth is enabled or disabled.
This parameter enables or disables prompt mode for WLAN Profile 1 only, where
user credentials are not saved to flash.
This parameter controls the frequency of audible alerts when the phone is out of
range of an access point. If disabled, the phone does not play audible alerts. If
enabled, the phone can beep once or regularly at a selected interval (10, 30, or 60
seconds) when it is out of range of an access point and once the phone is
reconnected to an access point, audible alerts will stop.
This parameter controls when the phone performs scanning. If Continuous is
selected, then the phone scans continuously even when it is not in a call. If Auto
is selected, then the phone scans when it is in a call or when the received strength
signal indicator (RSSI) threshold has been met when not in a call. If Single AP is
selected, then the phone does not scan except when first powered on or when the
connection is lost.
This parameter specifies the URL which the phone utilizes for application
services including Push To Talk (PTT).
This parameters specifies the amount of time one must hold down the Application
Button to activate the application specified in the Application URL. The timer
values are in seconds. A value of 0 indicates that a simple push of the Application
Button will active the application. For non-zero values, the application is
activated after the specified timer value expires.
This parameter specifies the priority of the Application Button relative to all other
tasks on the phone. If set to Low, then the Application Button only works when
the phone is idle and on the main screen. If set to Medium, then the Application
Button takes precedence over all tasks on the phone except when the phone
keypad is locked. If set to High, then the Application Button takes precedence
over all tasks on the phone even if the phone keypad is locked.
This parameter specified the emergency numbers that can be dialed without
unlocking the phone keypad. For example, in the United States, the 911
emergency number is a good candidate so that it can be dialed without unlocking
the phone. To specify more than one number, use a comma as separator. For
example, if you want to enter 411, 511, and 911 as emergency numbers, then
enter 411,511,911 in the field without spaces.
This parameter controls the behavior of the "Send" (green) key when it is pressed.
If On-hook Dialing is selected, then the phone will remain on-hook. If Off-hook
Dialing is selected, then phone sends an off-hook message.
130