Ttp8: Access Door Unlocks When Area Is Disarmed; Ttp9: Access Door Does Not Relock After Clearing A Fire Alarm And Resetting The Control Panel - Bosch D9412GV2 Troubleshooting Manual

.
TTP8: Access Door Unlocks When Area Is
Disarmed
Description
When the Auto Door programming prompt is set to
Yes, the access door locks when the area is armed, and
unlocks when the area is disarmed. Set this prompt to
No.
Procedure
1. Identify the door number that unlocks when
disarming by locating the appropriate D9210B
and reading its DIP switch address. Refer to
Table 14.
2. In programming, select RADXAXS→Door
Profile. Select the door identified in Step 1.
3. Change the Auto Door prompt from Yes to No.
4. Exit programming, then test the affected access
door.
Table 14: D9210B DIP Switch Addresses
Door Controller Address
Device 1
D9210B #1 ON
D9210B #2 OFF
D9210B #3
ON
D9210B #4 OFF
D9210B #5 ON
D9210B #6 OFF
D9210B #7 ON
D9210B #8 OFF
Bosch Security Systems, Inc. | 11/05 | F01U011024B
D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0 Troubleshooting
TTP9:
Description
This is normal operation for the control panel.
Unlocked access doors must be manually relocked.
Procedure
1. At a keypad, press [COMMAND][4][6]. Enter a
2. If using a D1255 keypad, when CYCLE DOOR?
3. Using either a D1255 or D1260 keypad, select
2 3
ON ON
ON ON
4. To relock an unlocked access door, enter the door
OFF
ON
OFF ON
ON OFF
5. Press [MENU/ESC] until the idle text appears.
OFF
ON
OFF OFF
OFF OFF
Access Door Does Not Relock after
Clearing a Fire Alarm and Resetting
the Control Panel
valid passcode if needed.
appears on the display, press [NEXT] once.
UNLOCK DOOR.
The display shows UNLOCK: U U U U U U U U.
If the door is locked, the door's number
-
appears.
If the door is unlocked, "U" appears in the
-
door number's place.
If a door is not active, "--" appears in the door
-
number's place.
The D9412GV2 supports up to eight
doors; the D7412GV2 supports up to four
doors.
number and press [Enter]. The "U" changes to the
door's number.
23