Dürkopp Adler 550-867 Operating Instruction page 58
Hide thumbs
Also See for 550-867:
- Service instructions manual (290 pages) ,
- Additional instructions (20 pages) ,
- Additional instructions (28 pages)
Table of Contents
Advertisement
56
Fig. 41: Remaining thread monitor during use (4)
④
(4) - Milling groove
Important
Insert the bobbin so that the milling groove (4) is pointing down.
6.
Change the bobbin ( p. 37).
7.
Use Sew on the control panel to re-activate sewing mode.
You can start a new seam.
Important
If the empty bobbin has not been replaced with a full one, the
control panel will display the error message again when you start
the next seam.
8.
Wind on the hook thread, ( p. 41).
Operating Instructions 550-867 - 00.0 - 11/2016
Operation
Advertisement
Table of Contents
