Advertisement
V. FRAME
83
r
8. Remove the rear wheel, rear shock absorbers and rear fork.
9. Remove the front wheel, front shock absorbers, steering
handle-bar and steering sterno
lO. Remove the rear fenders by loosening off the bolts and
nuts.
Disconnect the wire leads of the turo signal and tail/stop
lamp before removing the fenders.
Il.
Disconnect each wiring at the connector. Remove the
starting magneti c switch, regurator, turo signal relay, silicon
diode rectifier, horn and ignition coil.
12. Remove the wire harness from the frame.
Fig. 5-77
(1) Rear fender
(2) Front rear fender
13. Remove the brake pedal, stop switch, main stand and side
stando
Fig. 5-78 (1) Brake pedal (3) Side stand
(2) Main stand
14. Disassemble the fuel cock.
Lossen off the screws and remove the plate, washer, lever,
spring, O-ring and valve from the fuel cock body.
Fig. 5-79.(1)
Fuelcockbody
(4)Spring
(2) Valve
(5) Cock lever
(3) O-ring
(6) Washer
(7) Lever setting
plate
Inspection
1. Check the entire frame distortion, damage, crack or any
other defect.
2. Check the
steering head pipe far
misalignment or
deformation.
3. Check the wire harness, connectors far breakage, proper
connection, damage or any other defect.
4. Check the fuel tube far deterioration; also far cracks or any
other imperfections.
S. Check the fuel filler cap far clogging.
6. Check the fuel tank far deformatlon, cracks or other
sign of leaks. Also check the interior and, if necessary,
clean.
7. Check the side stand far wear, damage or any other defect.
Also check the proper return operation. (See page 20.)
8. Check the muffler pre-chamber gaskets far damage.
9. Check the valve faces of the fuel cock far scores or any
other damage.
1'1g. J-OU ~J} ruc, 'wc, ''''l'
(2) Fuel filler cap hole
Advertisement
