Advertisement
IV. ENGINE
39
rnspection
1. Measure the thickness of the friction disco
Standard value: 3.42-3.58mm (0.1 35-0.1 41-in.)
Service limit:
3.lmm (0.122-in.)
2. Check the clutch plate for face runout.
Standard value: 0.15mm (O.O06-in.) max.
Service limit:
O.35mm (O.OI4-in.)
3. Measure the free length of the clutch spring.
Standard value: 40.lmm (1.575-in.)
Service limit:
3.94mm (1.55-in.)
Fig. 4-57
(1) Outch friction disc
Assembly
1. FilI the clutch lifter steel hall hole and its screw end
with grease.
"1g. 4-58
(l) Outch lifter
(2) Screw end
(3) Steel hall
2. After installing the snap ring, check the operation of the
clutch center. It should rotate freely without binding.
i"ig. 4-59
(1) Snap ring
(2) Clutch center
3. He su re to install the clutch lifter roci anci the clutch litter
joint piece in their proper locations.
4. lnstail the clutch pressure plate so that its arrow mark is
aligned to one of the cut.out of the clutch center splines.
5. After assembling, adjust the clutch properly.
1'.g. 4-60 (1) Arrow
(2) Cut-out or the spline
Advertisement
