Advertisement
69
V. FRAME
3. STEERING
~
Fig. 5-27
(1) Steering handlebar
(2) Throttle grip
(3) Throttle grip pipe
(4) Right hand switch housing
(5) Upper holder
(6) Left hand grip rubber
(7) Outch lever
(8) Left hand switch housing
(9) Outch switch
(10) Outch cable
(11) Throttle cable
(12) Lower holder
(13) Steering stem nut
(14) Fork top bridge
(15) Steering head top thread
(16) Top cone race
(17) Stee1 hall (1/4 ")
(18) Top ball race
(19) Bottom hall race
(20) Bottom cone race
(21) Steering head dust seal
(22) Dust seal washer
(23) Steering stem
Disassembly
Steering handlebar
l. Remove the master cylinder, take care not to spill brake
fluido
2. Disconnect the clutch cable at the clutch lever.
3. Loosen off the screws securing the engine stop and starting
switch housing. Separate the housing and disconnect the
throttle cable end from the throttle grip pipe.
4. Open the seat and remove the fuel tank.
5. Disconnect the tUffi signal switch, dimmer switch, horn
switch, starting switch and engine stop switch wire lead
connections at the connector case.
6. Remove the headIight beam and disconnect the clutch
switch wire leads in the headIight case.
Fig. 5-~8
(1) Throttle grip pipe
(2) Throttle cable end
7. Remove the bolts securing the upper holders. Take out the
holders and steering handlebar.
Advertisement
