Hobby ONTOUR Operation Manual page 89

85
7. Installation of electrical devices
This check should be carried out at least once a month to ensure that
the residual current device functions perfectly in case there should be
a fault in the current.
When the FI switch has been set off (even when te-
sting) the customised settings in all mains-operated
devices are lost and the default settings made by the
manufacturer will apply again.
If the automatic circuit breaker has gone off (other than if the Test
function has been used) you must wait a short while before swit-
ching it on again.
- If the automatic circuit breaker remains active, there was only an
overload.
- If the automatic circuit breaker goes off abruptly again, there is
either a short circuit or an earth fault.
Devices that set off during operation show that there is a defect; they
must be checked and/or repaired by an electrical engineering specialist.
Switching it back on again and again will do no good.
The automatic circuit breaker also goes off when the
rocker switch is held firmly in place.
Operation via base vehicle
During the drive, the battery of the base vehicle takes over the supply
of the 12 V devices if contact 9 of the 13-pole socket system on the
base vehicle has been equipped.
Use the main switch on the control panel to switch off 12V operation
(when the trailer is hooked to the car) on longer stopovers and breaks
to conserve power in the car's battery.
When running on 12 volts, the refrigerator only functions if the motor
of the base vehicle is turned on. Contacts 10 and 11 of the 13-pole
socket system.
Always switch off the electric connection between the
base vehicle and the caravan before hooking the cara-
van up to a low-voltage supply.
If operation is carried out via the base vehicle, a maxi-
mum of 2 electrical devices in the caravan can be swit-
ched at the same time using the control panel (exception:
the self-sufficient package has been installed).