Hobby ONTOUR Operation Manual page 129

Control panel for the hot water heating
system
D E F G H
C
B
A
J
Basic menu
Settings menu
125
To start the hot water heater
To start the heating system, press the On/Off button and the start
image will appear. The heater will start with the settings that were
last used.
I Idle position
A. Clock. The clock shows the date and time (when activated).
B. *Outside temperature. The outside temperature is displayed.
C. Inside temperature. The inside temperature is displayed.
D. Circulation pump. This icon is displayed when the circulation
pump is in operation.
E. Starting the heating system automatically. This icon is displa-
yed when this function has been activated.
F. Daytime automatic system. This icon is displayed when this
function is activated.
G. *Liquid gas bottle full/empty. This icon is displayed when the
sensor on the gas regulator of the bottle is connected and has
been activated. Is a de-icer* has been installed, the icons will be
K
displayed for the set mode together with the bottle icon.
H. Nighttime automatic system. This icon is displayed when this
function is activated.
I. 230 volts. This icon is displayed when a voltage of 230 V is
applied to the heating system.
J. On/Off button. Main switch for the heating system.
K. MENU key. Key for the settings menu.
The functions marked ( * ) are accessories. They have not been
installed in every vehicle.
Settings menu
Start the settings menu by pressing the MENU key. The backlight
goes on and those functions that can be set will be displayed. The
control unit will switch to the idle position after 30 seconds if the
screen is not operated.
The temperature can be set from +5 °C to +30 °C in steps of
0.5 °C.
1. The temperature shown is the temperature presently set.
2. Raise the temperature by pressing "+". Lower the temperature by
pressing "–".
3. The settings are now finished and the heating will run until the set
temperature has been reached.
Setting the desired temperature
10. Built-in devices