Hoover STEAMVAC Owner's Manual page 5

Attach tool holder
Remove tool and taped screw from rack.
Insert projections on rack into slots on
back of cleaner.
Continue wrapping hose over upper
hose hook (E) and under lower hook (F).
Snap hose end fully into holder (G).
Ensure that the hose end is pushed
down completely into holder (G).
The powered hand tool is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open-
ing tool door.
Slide rack down into place. Insert screw
at (D) and tighten with a Phillips screw-
driver,
Position tool in holder at base of cleaner
and snap It into place as snown at
arrow.
To remove tool, pull it down and out-
ward.
To reposition the tool, reverse this proce-
dure.
Storing hose & tools
Store hose on holder by first positioning
hose in front section of holder.
Insert end of bare floor attachment into
holder and snap into clip as shown.
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
5