Hoover STEAMVAC Owner's Manual page 4

The assembled cleaner-will look like this.
drawing.
Place nuts in recessed areas on back of
handle. Hold each nut in place while
tightening each bolt securely with a
Phillips screw driver.
Only two nuts are needed on this model.
The extra-nut is not required but has
been provided for your convenience.
Press cord into cord clip on back of
handle. Pull cord tight.
4
Assemble
handle
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
When handle sections are completely
together, squeeze trigger (B) on upper
handle to snap trigger rod Inplace.
Position hole holder (C) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
push upper handle down onto lower hani
dle. If bolts will not go tlirough hole e&i-
Replace clean solution tank (upper
tank) by positioning bottom first. Press
on tank handle to snap top of tank into
p l a c e .
Place nuts in recessed areas on back
of handle. Hold each nut in place while
tightening each bolt securely (from the
front of then handle) with a Phillips
screw driver.
Only two nuts are needed on this
model. The extra nut is not required but
has been provided for your conve-
nience.