Removable Brushes - Hoover STEAMVAC Owner's Manual

Hide thumbs Also See for STEAMVAC:
Table of Contents

Advertisement

Read "Before you begin cleaning"
Instructions on page 9.
Be sure to check the cleaning code on
your upholstery. Use your HOOVER
upholstery marked "W" or "W/S".
Place handle in upright position.
Agitator brushes will not rotate while
handle Is In upright position.
Fill clean solution tank with HOOVER
Carpet/Upholstery Detergent according
to instructions on pages 7 and 8. Attach
tool to end of hose.
Do not point tools toward people or
pets.
Dry hands and plug deep cleaner into a
properly grounded outlet.
For heavily soiled areas, it may be nec-
essary to repeat the cleaning process.
Make
crisscrossing strokes to the origi-
nal pattern; overlap each pass,
Make no more than 2 passes with the
solution over any one area to prevent
over-wetting and damage to fabric.
If additional cleaning is necessary, wait
until the upholstery is completely dry
before using the tool again.
Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", page 7).
When finished cleaning, follow "After
cleaning" instructions on page 9 and
"After using tool" instructions on page 12.
Turn deep cleaner on.
Gently press the tool (A) or (B) onto the
fabric. Press the trigger and slowly pull
the nozzle over the fabric,
Overlap strokes by l/2 inch to help pre-
vent streaking.
Make additional strokes without pressing

Removable brushes

Your deep cleaner is equipped with
removable brushes for easy cleaning.
To remove brushes
Disconnect cleaner from electrical
outlet.
To prevent possible leaking, remove
clean solution tank and recovery tank.
Set tanks aside.
Press handle release pedal to lower han-
dle. Turn cleaner over so bottom is fac-
ing up.
the trigger to remove more moisture.
To clean in corners or creases, lift the
tool one-half inch from the fabric and
press the solution trigger.
Vacuum up the solution with the tool
without pressing the trigger.
Grasp inner portion of brush (A) and
pull brush assembly out slightly to
reveal latches (B).
Press all four latches (B) and pull brush
out.
block
The brushes can be cleaned
under running water.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents