Using A Magnetic Stripe Reader (Msr) Or I.d. Badge Reader - PSC Mini PowerWedge User Manual

Using a Magnetic Stripe Reader (MSR) or
After completing the installation, you can replace the bar code reader
with a magnetic stripe reader or I.D. badge reader.
To attach an MSR or I.D. badge reader . . .
1. Move the On/Off/Program switch on the Mini PowerWedge
to the
OFF
2. Remove any device attached to the
Mini PowerWedge.
3. Plug the MSR or badge reader connector into the
nector.
4. Move the On/Off/Program switch to the
WARNING
User's Guide
I.D. Badge Reader
position (see Figure 1-1).
Always make sure the On/Off/Program switch on
the Mini PowerWedge is in the off position before
attaching or removing a magnetic stripe reader or
I.D. badge reader. Having the switch in any other
position may damage the decoder, input device, or
computer.
connector on the
INPUT
INPUT
position.
ON
con-
5