Table of Contents
Advertisement
8.
When you are finished checking or changing parameter set-
tings, type EE at the prompt and press
your changes and exit on-screen programming.
NOTE
9.
If you are programming in DOS, press
the DOS prompt.
Displaying and Printing Current Settings
While you are in on-screen programming mode, you can display the
current settings for all the parameters. At the main menu prompt,
type E and press
the next prompt, type 1 and press
will appear on your screen. To pause the display of the list at any
time, press the
PAUSE
continue the display.
If you are using a text editor, you can use commands in the editor's
menu to print the list of settings or save it to a file. If you are working
from the DOS prompt, you can also save or print the list of settings.
To print or save the list, follow steps 1 through 9 above, with the fol-
lowing changes in step 2:
•
To print the list, use the following command: copy con prn.
•
To save the list as a file, use the following command: copy
con filename.
User's Guide
To leave on-screen programming without saving any
changes, type EF and press
, and then type D and press
ENTER
key on your keyboard; then press any key to
ENTER
.
ENTER
CTRL
. A list of all the parameters
ENTER
. This will save
+
to return to
Z
again. At
ENTER
19
Advertisement
Table of Contents
