You can attach a serial device to the
PowerWedge. The serial device must operate with the following set-
tings:
•
9600 baud
•
8 data bits
•
No parity
•
1 stop bit
•
End-of-record character = carriage return
To attach a serial device . . .
1.
Attach a wand, laser, or CCD to the
Mini PowerWedge.
2.
Move the On/Off/Program switch on the Mini PowerWedge
to the
ON
3.
Scan the following bar code with the bar code reader:
*$+$-D410EE*
This puts the Mini PowerWedge into serial input mode (see "Laser/
Input Modes" on page 8).
4.
Move the On/Off/Program switch on the Mini PowerWedge
to the
OFF
5.
Remove the device attached to the
6.
Attach the female connector of the serial input cable (part
number 00-874-24) to the
Wedge.
NOTE
7.
Plug the male connector of the serial input cable into the con-
nector on the serial device.
6
Using a Serial Device
position.
position.
To make your own serial input cable, see the pinout
diagram in the Mini PowerWedge Programming Ref-
erence.
connector on the Mini
INPUT
INPUT
INPUT
connector on the Mini Power-
INPUT
connector on the
connector.
Mini PowerWedge
®