Laser/Input Modes; Normal Mode; Autoscan Mode; Multiscan Mode - PSC Mini PowerWedge User Manual

The Mini PowerWedge can operate in any of the following modes:
In normal mode, the Mini PowerWedge accepts bar code or magnetic
stripe input from all supported types of input devices except serial
devices. This is the default setting for the Mini PowerWedge's laser/
input modes.
Use this mode for stand-mounted lasers. This mode returns the laser
to the ready-to-read state immediately after each read.
This mode allows you to scan bar codes without pressing and releas-
ing the trigger for each read. In this mode, the laser or CCD remains
in the ready-to-read state for as long as the trigger is held down.
Use this mode for automatic scanning with a Symbol laser mounted
on the Symbol IntelliStand.
In this mode, the Mini PowerWedge accepts input from serial devices
or wands. All other input is disabled.
NOTE
8

Laser/Input Modes

Normal Mode

Autoscan Mode

Multiscan Mode

Symbol Blinking Mode

Serial Input Mode

Bar codes for setting laser/input modes are on page
56.
Mini PowerWedge
®