Set Up Sonar (Sonar, Di, Si, Chirp) - Humminbird HELIX 5 G2 SERIES Operation Manual

S S
ET UP ONAR
The available sonar views and menus on the control head are determined by the connected transducer and the selected transducer
source.
Most of the settings in this section were set up when you first powered on the unit using the Quick Setup Menu. Use
the instructions in this section to adjust those settings, set up an accessory transducer, or refine the information
shown on-screen.
Set up an Accessory Transducer
The control head will automatically select the transducer that was included with your control head. If your model is compatible with
an accessory transducer, and it is connected to the control head, select the transducer in the system so the beams are activated
and the related views are added to the control head. See Getting Started: Quick Setup for more information.
NOTE: To see the latest transducers that are compatible with your control head, visit our Web site at humminbird.com.
1. Main Menu: Press the MENU key twice. Select the Sonar tab.
2. Select Connected Transducer.
3. Select the transducer connected to the unit.
To adjust the depth offset, see Manage your Control Head.
Adjust the Noise Filter
Use Noise Filter to limit the interference that may appear on the sonar views from sources such as your boat engine, turbulence,
or other sonar devices.
1. Main Menu (Advanced User Mode): Press the MENU key twice. Select the Sonar tab.
2. Select Noise Filter.
3. Select a filter setting, where Low is the lightest filter and High 3 filters the most interference.
Off: removes all filtering.
High: The high settings are useful when there is excessive trolling motor noise. However, in some deep water situations, the
High settings may hinder the control head's ability to find the bottom.
Set up Sonar 36
(S , DI, SI, CHIRP)
ONAR