Mercury 5 SERIES Service Manual page 175

Powerhead Installation
1. Secure powerhead (with new gasket) onto drive shaft housing using 6 bolts. Torque
bolts to 70 lb-in. (8 Nm).
a -
2. Install the following components/assemblies referring to the listed service manual
section(s).
a Rewind Starter
b Flywheel/CDI Unit/Ignition Coils
c Carburetor
d Fuel Pump
e Throttle Linkage
90-857138R1 MAY 2000
Powerhead Mounting Bolt Torque
a
Powerhead Mounting Bolts with Washers (6) M6 x 30 mm
Component/Assembly
CYLINDER BLOCK AND CRANKCASE
70 lb-in. (8 Nm)
56327
Section
8
2A
3B
3A
7
Page 4B–43