Table of Contents
Advertisement
Printing Using the Computer
c
Select [Infrastructure Mode] using the
d
Select [Network Setting] using the
e
Select [Setup Wizard] using the
f
If any messages appear, press the OK or Enter key for each message.
The SSIDs for the available networks appear.
g
Select the SSID using the
characters), and then press the OK or Enter key.
The [Password] screen appears.
h
Enter the password (from 8 to 63 characters or, when using WEP, from 5 to 13 characters), and then
press the OK or Enter key.
i
The screen returns to the [Settings] menu screen, and
established.
After 90 seconds, the indicator will change to
the network.
j
When connected, depending on the strength of the wireless signal, the wireless connection indicator
shows of the following symbols:
Note
If you start the setup wizard for the Infrastructure mode or select the network settings for the Direct mode
when the wireless function of the machine is turned off, [Turning on Wi-Fi Radio] appears and the
wireless function turns itself on automatically (or after the OK key is pressed). It is no longer necessary to
turn the Infrastructure mode or Direct mode on manually.
or
key, and then press the OK or Enter key.
or
key, and then press the OK or Enter key.
or
key, and then press the OK or Enter key.
or
key, or select [Other...] and enter the SSID (from 1 to 32
, but your machine will continue trying to connect to
blinks while the connection is being
4
64
Advertisement
Table of Contents
