Otto Bock discovery tmax Instructions For Use Manual page 19

3) Tighten the Allen head screw to a torque of 8 Nm.
Multifunction footrest
The angle can be adjusted in 2 directions:
1) Angle adjustment for equinus position/talipes calcaneus: Loosen the Allen head screw on the footplate
joint (see fig. 30; item 1) and turn the footplate to the desired angle (see fig. 30; item 2).
2) Angle adjustment for supination/pronation: Turn the adjustment screw under the footplate in or out (see
fig. 30, item 3). Set the footplate to the desired angle in this manner (see fig. 30; item 4).
3) Tighten the Allen head screw (see step 1) to a torque of 6 Nm.
29
Footrest for short lower leg lengths
1) Loosen the upper clamping screw (see fig. 22, item 2). The lower clamping screw may also have to be
loosened (see fig. 22, item 1).
2) Bring the footplate to the desired position (see fig. 22, item 4).
3) Tighten the clamping screws to a torque of 9 Nm.
Elevating footrest
Elevating footrest (plastic): see the section "Standard footrest" for making adjustments.
Elevating footrest (metal): see the section "Aluminium footrest" for making adjustments.
Centre footrest
1) Loosen the Allen head screw on the pivot bearing of the footplate (see fig. 31, item 1).
2) Turn the mounting in the pivot bearing until the footplate reaches the desired angle (see fig. 31, item 2).
3) Tighten the Allen head screw to a torque of 8 Nm.
31
Single-panel footplate
The angle cannot be adjusted.
discovery tmax
30
Adjustments
Ottobock | 19