Configure Stack On The Second Switch; Verify Stack Configuration; Configure Out Of Band (Oob) Management Port - Dell S4048-ON Configuration Manual

System configuration has been modified. Save? [yes/no]no
Proceed with reload [confirm yes/no]yes
Note: The switch will reboot.
5.4

Configure stack on the second switch

Dell>enable
Dell#stack-unit 1 renumber 2
Note: After confiming configuration change, the switch will need to reboot.
Dell#configure
Dell(conf)#stack-unit 2 priority 1
Dell(conf)#stack-unit 2 stack-group 12
Dell(conf)#stack-unit 2 stack-group 13
Dell(conf)#exit
Dell#copy running-config startup-config
Dell#reload
5.5

Verify stack configuration

From the first switch (Master) CLI, confirm that the stack has formed:
Dell#show redundancy
Dell#show boot system stack-unit all
Note: The MASTER LED on the switch front panel will show a steady light for the master unit and a
blinking light for the standby unit. All of the following configuration steps must be performed from the
master switch.
5.6

Configure out of band (OOB) management port

Dell#config
Dell(conf)#interface ManagementEthernet 1/1
Dell(conf-if-ma-1/1)#no shutdown
Dell(conf-if-ma-1/1)#ip address ipaddress mask
Dell(conf-if-ma-1/1)#no shutdown
Dell(conf-if-ma-1/1)#exit
16 SCG1026 Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs