Table of Contents
Advertisement
5.2 Installation and connection
•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is stable.
•
Not at any time should you place the device on an inflammable surface.
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The working and packing surface must be easily accessible, dry, and
appropriately large.
•
Never place the device in a moist or wet place.
•
Never place the device on the edge of the working surface.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect
the device if the need arises.
- 23 -
Advertisement
Table of Contents
