Malaguti Centro 125 Service Manual page 23

125 i.e. - 160 i.e.
TAIL LIGHTS
• Tail light (B)
Light bulb 12V - 5W (W5W).
• brake light (S)
Light bulb 12V - 10W (R10W).
• Turn signal (E) 12V-10W light
bulb
F. 32
NUMBER PLATE LIGHT
Light bulb 12V - 5W (W5W)
To check that a light bulb (C ) is
properly functioning, position the
light switch, which is located on
the right control panel, in the
center position and turn the key
to the starting position.
F. 34
W S S
E
B
C
LIGHT BULB REPLACEMENT
W
• Remove the number plate light (see the next
paragraph).
• Remove the taillight cover by unscrewing the two
E
screws (V).
• Remove the parabola by unscrewing the two screws
(W).
Tail lights (B)
• Take out the lamp holder from inside the headlight.
• Replace the light bulb.
• Reposition the rubber lamp holder (pressure) and
remount the cover.
B
Stop light (S) and turn signal light (E)
• Remove the coloured hood that is held by two hooks.
• Replace the light bulb.
• Reposition the coloured hood and remount the cover.
When performing the operations described
above, be very careful to not damage the near
by parts (transmission, cables, gaskets, etc.).
LIGHT BULB REPLACEMENT
• Remove the number plate light (F), unscrew the screws
(V).
• Remove the rubber lamp holder from the plastic cover.
• Replace the light bulb.
• Reposition the lamp holder and remount the cover.
When performing the operations described
above, be very careful not to damage the near
by parts (transmission, cables, gaskets, etc.).
22 11/07
V
V
F. 33
F
V
F. 35