Adjusting The Mounting Bracket - Oki Microline 3320 User Manual

CUT-SHEET FEEDER
the
Adjusting Mounting Bracket (for use of a CSF 3390-S or 3390-D on ML
3321/3391)
You will need a #2 Phillips-head screwdriver for this
1. Remove
screw
2. Turn the Cut-Sheet Feeder upside down on a flat, sturdy surface.
3. Loosen and remove screws B from the left and right ends of the
mounting brackets C and
4. With the Cut-Sheet Feeder facing downwards, carefully pull the left
end of the mounting bracket away from the feeder
5. Extend the left end of the mounting bracket
A
for screws and
D
bracket out to the right side until the three holes
right side (approx.
(18 inches) in width.
A
from the inside of the output
D .
B
align again (approx.
150
mm). The extended bracket
procedure.
tray.
body.
C
until the three holes
5 mm). Extend the
align on the
will be 457.2 mm