Printing With The Cut-Sheet Feeder - Oki Microline 3320 User Manual

Printing with the Cut-Sheet Feeder

After the first sheet is inserted and the Top of Form is set, you can begin
printing with the CSF. Simply request a printout from your word process-
ing package as you would normally. When it receives the command to
print, the printer will start printing on the inserted sheet, eject the printed
page into the stacker; and insert a new page. When files are several pages
long, the printer will eject each printed page into the stacker, insert a new
sheet from the CSF loading tray, then continue printing.
If you are writing your own program for the Cut-Sheet Feeder, you must
include the CSF insert and eject commands. When the printer receives the
command to print, it will insert a sheet of paper and start printing. Each
time it receives the CSF insert command, it ejects the printed sheet, then
insert a new sheet. Use the CSF eject command at the end of your own
program if you want the printer to eject the printed sheet without insert-
ing a new sheet.
If you want to eject a sheet of paper manually, simply press the FF/LOAD
button.
For a chart commands, see Appendix
NOTE: Ensure that the printer's page length is not less than that in your word processing
program.
The effect of the LINE FEED command depends on the status of the CSF as
follows:
- If there is no paper in the CSF, a sheet will be fed in after a LINE FEED
command and the subsequent characters appear on the first print line
at the top of the sheet.
- If there is a paper in the CSF, the LINE FEED command cause a line feed.
- If the printhead is on the last print line of the sheet, the sheet will be
ejected after a LINE FEED and a new sheet fed in. The
line of the new sheet is then the actual printing position.
2. OPERATION
A.
first
printable