Instruction Manual
INSTALLING THE flap LINKAGE
Repeat step #1 - #9 from installing the aileron
linkage to install the flap linkage.
INSTALLING THE WING TO THE FUSELAGE
Attach the wings to the joiner tube and secure
the wing panels to the fuselage.
Screw
HORIZONTAL STABILIZER INSTALLATION
1. Using a modeling knife, cut away the covering
from the fuselage for the stabilizer and remove it.
Remove the covering
2. Draw a center line onto the horizontal stabilizer.
15
3. Check the fit of the horizontal stabilizer. Make
sure the horizontal stabilizer is square and
centered
measurements, but don't glue anything yet.
16
4. With the horizontal stabilizer correctly aligned,
mark the shape of the fuselage on the top and
bottom of the tail plane using a water soluble /
non-permanent felt-tip pen.
17
18
4
CESSNA 182
Remove the covering
to
the
fuselage
by
19
taking
20