Wire Connection; Center Post Assembly - GB BGB300 Owner's Manual

A s s e m b l y S t e p 4

Wire Connection

Remove the Rubber Ring (#59) and Center Post Cover
(#34) from packaging and slide them onto and up the Center
Post (#04) for now. Then, connect the Main Sensor Wire
[Middle] (#45b) to the Main Sensor Wire [Lower] (#44) .

Center Post Assembly

Slide the Center Post (#04) onto the Main Frame (#01)
and secure it using a total of four Arc Washers (#28) and
four Screws (#23).
Center Post Cover
Then, slide down the Center Post Cover (#34) and Rubber
and twist/turn clockwise so it fits properly and
Ring (#59)
snugly over the Main Frame (#01) . Please refer to positioning
of the Center Post Cover (#34) and Rubber Ring (#59)
in the diagram below.
BGB 300
Assembly Instructions
Hardware & Tool Required
Bolt
#23 Screw (M8x16 mm) [4 Pieces]
Washer
STEP3:
#28 Arc Washer (M8) [4 Pieces]
Tool
55
40
1 2 3 4
55
40
1 2 3 4
Page 7