Seat Post Assembly; Pedal Assembly - GB BGB300 Owner's Manual

A s s e m b l y S t e p 3

Seat Post Assembly

A.) Attach the Horizontal Seat Bar (#08) onto the Seat Post (#07) by
inserting the bolt (on the bottom of the
through the Seat Post (#07), secure them using a Washer (#29)
and a Knob (#16). This knob can be loosened to adjust the distance
of the seat from the handle bars. Make sure to tighten the knob after
making any adjustment, but do not over tighten the knob.
B.) If the Seat Post (#07) is not already pre-assembled, please insert
the Seat Post (#07) into the mouth of the post that is protruding
from the Main Frame (#01). Please ensure that the hole on the Seat
Post (#07) is facing the right so it can be aligned with the corresponding
hole on the Main Frame (#01). Screw in the Spring Knob (#17)
through the Main Frame (#01) post and through any hole located on
the Seat Post (#07). Please refer to illustration. To use the
safety-featured Spring Knob (#17), use one hand to hold the Seat
(#09) to prevent sudden slipping and the other hand to loosen the
knob by turning it counter-clockwise three times as you pull it outward.
Adjust the seat height to your liking and then pop the knob back in.
Then, tighten the knob by turning it clockwise. Please do not
over-tighten.

Pedal Assembly

Pedal [Left](#10L) to the Crank [Left] (#56L) by turning
Screw the
bolt head on the Pedal [Left](#10L) COUNTER-CLOCKWISE.
Screw the Pedal [Right](#10R) to the Crank [Right] (#56R) by turning
the bolt head on the Pedal [Right](#10R) CLOCKWISE.
W A R N I N G
Do not remove the Seat (#09) for any
reason after you have installed it.
Exercising on this unit without the Seat
(#09) can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
BGB 300
Assembly Instructions
Horizontal Seat Bar (#08))
Hardware & Tool Required
Washer
#29 Washer (M10) [1 Piece]
Knob
STEP3:
#16 Knob (M10) [1 Piece]
#17 Spring Knob (M16x27 mm) [1 Piece]
Tool
55
the
40
1 2 3 4
A
B
NOTE:
If labels designating the Left/Right Pedal
are not present, please check pedals
closely for embossed "L"/ "R" letter marks.
These will be "L" / "R" letters that are
raised on the pedal material.
55
40
1
Spring Knob Operation
Turn knob counter-clockwise
three times.
Pull knob outward and adjust
seat simultaneously
Push knob back inward until
it clicks and then tighten it by
turning clockwise.
2 3 4
Page 6