GB BGB300 Owner's Manual page 10

A s s e m b l y S t e p 5
A.Place the Poster Support (#11) onto the corresponding
stem protruding from the Center Post (#04). Secure in
place using the Knob (#18) and tighten in place. You can
adjust the Poster Support (#11) location to your preference
by securing at the preferred angle.
B.Affix the Poster Board (#12) onto the plate of the Poster
Support (#11) using four Washers (#30) and four Screws
(#25).
C.The Poster Board (#12) and Poster Support (#11) are
intended to provide an easy-to-access guide to highlight
the key features and functions of the Game Rider. We
suggest placing the Poster Board (#12) at a 45 degree
angle to the user on either the right or left side.
C
BGB 300
Assembly Instructions
B
A
A s s e m b l y S t e p 6
Pulse Handle Bar Assembly
Install the Handle Bar (#05) onto the inner side of the
Center Post (#04) using two Screws (#22) and two
Spring Washers (#27) as seen in diagram.
Hardware & Tool Required
Bolt
#22 Screw (M8x25 mm) #25 Screw (M5x10 mm)
[2 Pieces]
Washer
#27 Spring Washer (M8) #30 Washer (M5)
[2 Pieces]
Knob
#18 Knob (M8x15 mm) [1 Piece]
Tool
[4 Pieces]
[4 Pieces]
Page 8