Seat Assembly; Assembly Instructions - GB BGB300 Owner's Manual

A s s e m b l y S t e p 1
Front & Rear Stabilizer Assembly
With the help of an assistant, attach the Front Stabilizer
(#02) to bracket at the front of Main Frame (#01). Insert two
Carriage Bolts (#13) through the Front Stabilizer (#02)
followed by the front Main Frame (#01). Secure them
together using two Arc Washers (#28) and two Lock Nuts
(#15). Now attach the Rear Stabilizer (#03) to the bracket
at rear of Main Frame (#01). Insert two Carriage Bolts (#14)
through the Rear Stabilizer (#03) followed by the rear
Main Frame (#01). Secure them together using two Arc
Washers (#28) and two Lock Nuts (#15).
NOTE: The Front Stabilizer (#02) has wheels on the end
caps that spin for ease of relocating and transporting the unit.
The Rear Stabilizer (#03) has height adjustable end caps
for leveling of the unit .
Make sure the wire is hanging out before
proceeding to the next step. If it has fallen
inside the tube, use a bent wire to "fish" them out.
BGB 300

Assembly Instructions

A s s e m b l y S t e p 2

Seat Assembly

Remove the three Washers (#32) and three Nuts (#33)
that are pre-installed on the Seat (#09) as illustrated and
set them aside. Align the holes of the Seat (#09) to the
Horizontal Seat Bar (#08) as shown in the diagram.
Next, secure them together using three Washers (#32)
and three Nuts (#33) that were previously removed.
Hardware & Tool Required
Bolt
#13 Carriage Bolt (M8x73 mm)
[2 Pieces]
Washer
#28 Arc Washer (M8)
[4 Pieces]
Nut
#15 Lock Nut (M8) [4 Pieces]
Tool
#14 Carriage Bolt (M8x90 mm)
[2 Pieces]
#32 Washer (M8, OD16)
[3 Pieces]
#33 Nut (M8)
[3 Pieces]
Page 5