Front View; Back View - GB BGB300 Owner's Manual

A s s e m b l y S t e p 7
Feed the Left Handle Pulse Wire (#47) and the Right Handle Pulse Wire (#48) through the side hole in
the neck of the Center Post (#04) and through the front hole of the Center Post (#04) as directed by the
arrow in diagram No. 1. You will need to connect these wires to the Monitor (#43) in later assembly step.
Please also ensure that Handle Sensor Wire [Lower] (#46) and Main Sensor Wire [Middle] (#45) are fed
through the same hole as shown in diagram No. 2. Please refer to diagram No. 3 and No. 4 to confirm
proper assembly.
The Round End Cap (#42) is pre-installed to hold the Left & Right Handle Pulse Wires (#47 & #48) as
seen in diagram No. 2. However, you may remove the Round End Cap (#42) so you can tuck in the wires
more if there is too much give, or you do not want the wire to hang out so much. If you remove the Round
End Cap (#42), please remember to snap it back in place to hold all the wires in place.

FRONT VIEW

BGB 300
Assembly Instructions

BACK VIEW

Page 9