Srx5400 Services Gateway Spc Description; Figure 2: Typical Spc - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway SPC Description

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
SRX5400 Services Gateway FRUs on page 245
Each Services Processing Card (SPC) contains four Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec,
and IDP (see Figure 2 on page
to an SPU to have services processing applied to it. Traffic is intelligently distributed by
interface cards to SPUs for services processing.
The services gateway must have one SPC installed.
You can install an SPC in any of the slots that are not reserved for Switch Control Board
(SCB). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the device.
Figure 2 on page 7 shows a typical SPC supported on the services gateway.

Figure 2: Typical SPC

For detailed information about SPCs supported by the services gateway, see the
SRX5600, and SRX5800 Services Gateway Card Reference
Installing an SRX5400 Services Gateway SPC on page 175
SRX5400 Services Gateway Card Cage and Slots on page 5
Maintaining SPCs on the SRX5400 Services Gateway on page 214
Troubleshooting SRX5400 Services Gateway SPCs on page 233
SRX5400 Services Gateway FRUs on page 245
Chapter 2: Hardware Component Overview
7). All traffic traversing the services gateway is passed
at
SRX5400,
www.juniper.net/techpubs/ .
7