Juniper SRX5400 Hardware Manual page 60

SRX5400 Services Gateway Hardware Guide
Description SPC with two SPUs
Software release Junos OS Release 9.2 and later
Cables and
CHASSIS CLUSTER CONTROL 0
connectors cluster configurations.
Supported SFP transceivers:
1000BASE-LH (model numbers SRX-SFP-1GE-LH, SRX-SFP-1GE-LH-ET)
1000BASE-LX (model numbers SRX-SFP-1GE-LX, SRX-SFP-1GE-LX-ET)
1000BASE-SX (model numbers SRX-SFP-1GE-SX, SRX-SFP-1GE-SX-ET)
Controls None
Supported Slots SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
Power Requirement Maximum 351 W
34
Each SPC consists of the following components:
SPC cover, which functions as a ground plane and a stiffener.
Two small form-factor pluggable (SFP) chassis cluster control ports for connecting
multiple devices into a redundant chassis cluster. See Junos OS Security Configuration
Guide for more information about connecting and configuring redundant chassis
clusters.
CAUTION: If you face a problem running a Juniper Networks device that
uses a third-party optic or cable, the Juniper Networks Technical Assistance
Center (JTAC) can help you diagnose the source of the problem. Your JTAC
engineer might recommend that you check the third-party optic or cable
and potentially replace it with an equivalent Juniper Networks optic or
cable that is qualified for the device.
Fabric interfaces.
Two Gigabit Ethernet interfaces that allow control information, route information, and
statistics to be sent between the Routing Engine and the CPU on the SPCs.
Two interfaces from the SCBs that enable the boards to be powered on and controlled.
Physical SPC connectors.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of
SDRAM.
LEDs on the faceplate that indicate the SPC and SPU status.
and
CHASSIS CLUSTER CONTROL 1
or
0 1
, , or
0 1 2/6
–SFP ports for control links in chassis
Copyright © 2017, Juniper Networks, Inc.