Wachendorff ur3274 User Manual page 49

Run n.c.
rn.n.c.
Lock Conversion n.o. (Lock visualisation on display
L.c.n.o.
with N.O. contact)
Lock Conversion n.c. (Lock visualisation on display
L.c.n.c.
with N.C. contact)
Tune > Manual
tune
Automatic Manual impulse
a.ma. i .
Automatic Manual Contact
a.ma.c.
Timer 1 Start Stop
t. 1 .s.s.
51 Gradient
Grad.
Rising gradient for soft start or pre-programmed cycle
0 Disabled > Default: 0.
1-9999 Digit/time
temperature)
52 Maintenance Time
ma.ti.
maintenance time for pre-programmed cycle
00.00-24.00 hh.mm > Default: 00.00
53 User Menu Cycle Programmed
u.m.c.p.
Allows the rising/falling gradient and the maintenance time
to be changed from the user menu in pre-programmed
cycle functioning.
Disabled > Default
dis.
Rising Gradient (modify gradient)
r i.Gr.
Maintenance Time (modify time)
ma.t. i .
Rising Gradient and Maintenance Time (modify both)
r.G.m.t.
Falling Gradient (modify cooling gradient)
fa.Gr.
Rising and Falling Gradient (modify rising and
r.f.Gr.
cooling gradient)
Falling Gradient and Maintenance Time
f.G.m.t.
7
The display of decimal point depends on the setting of parameter
and the parameter
(degrees/hours with display of tenths if
7
d.p.
UR3274U - User manual
sen.
49