Table of Contents
Advertisement
Insert the programming module when the controller is off.
On activation display 1 shows
(Only if the correct values are saved in the program-
----
ming module). By pressing the
, then confirm using the
Load
the new data and starts again.
When writing the parameters, the led turns red and on
completing the procedure it changes to green. It is possible
to repeat the procedure without any particular attention.
Updating programming module
To update the programming module values, follow the proce-
dure described in the first method, setting display 2 to
as not to load the parameters on controller
Enter configuration level and change at least one parameter.
Exit configuration. Changes are saved automatically.
Loading default values
7.9
This procedure allows to restore factory settings of the
instrument.
1
If on activation the controller does not display
have been saved on the programming module, but it is possible to
update values.
18
UR3274U - User manual
• With the controller not connected
to power supply.
The programming module is equip-
ped with an internal battery with an
autonomy of about 1000 uses.
Insert the programming module
and press the programming button .
and display 2 show
memo
key display 2 shows
key. The controller loads
.
1
memo
so
----
it means no data
Advertisement
Table of Contents
