Operation - Makita CL070D Instruction Manual

is not being inserted correctly.
Switch action
Fig.2
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes too full, or the
•
suction force weakens.
Be sure to empty out the dust inside the cleaner
•
itself. Failure to do so may cause the filter to be
clogged or the motor to be damaged.
Fig.3
In order to drop dust sticking on the filter in the capsule,
tap the capsule 4 or 5 times with your hand.
Fig.4
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
NOTE:
Dust may spill out when capsule is opened, so be
•
sure to set a garbage bag beneath capsule.
Fig.5
Remove accumulated dust from inside of capsule and
off of prefilter.
Fig.6
Twist prefilter in direction of arrow to unfasten securing
lip from cleaner unit and then pull off prefilter.
Fig.7
Clean out fine dust from prefilter. Next, remove filter, and
lightly tap to dislodge dust.
Reassembly
Fig.8
Put on filter until it is fully in position on the cleaner unit.
NOTE:
Make sure filter is put on straight without being
•
peeled back. If filter is put on incorrectly as shown
in diagram, dust will get into motor housing, and
cause motor failure.
Fig.9
Connect prefilter. At this time, make sure to twist prefilter
so that securing lip is firmly locked into cleaner unit.
Fig.10
Fig.11
Connect capsule. Align projection on capsule with
projection on handle and then firmly twist capsule in
direction of arrow until it is secured.
Fig.12
Fig.13
NOTE:
Always remove dust ahead of time, as suction
•
power will be reduced if there is too much dust in
cleaner.
Always be sure to check that both filter and prefilter
•
are loaded correctly prior to using cleaner. If they
are not loaded correctly, dust will get into the motor
housing, and cause motor failure.
If the following examples occur, filter and prefilter
are not loaded correctly. Reload them correctly to
rectify problem.
Problem Examples
Example 1: Only prefilter has been loaded (no filter)
Fig.14
Example 2: Only filter has been loaded (no prefilter)
Fig.15
Example 3: Filter has been loaded in a peeled back state
Fig.16
Example 4: Prefilter's securing lip is not firmly locked into
groove of cleaner housing
Fig.17

OPERATION

CAUTION:
To connect
•
twist-insert attachment in direction of arrow to
ensure secure
disconnect attachment,
direction of arrow.
If attachment is twisted in the opposite direction,
when being connected or disconnected, capsule
may become loose.
Fig.18
Cleaning (Suction)
Nozzle
Attach the nozzle to clean off tables, desks, furniture, etc.
Nozzle slips on easily.
Fig.19
6
attachments, such
connection during
twist-extract
as nozzle,
use. To
also in