Back Panel With Ports, Buttons, And A Dc Connector - NETGEAR D6220 User Manual

Table 1. LED and button descriptions (Continued)
LED Description
WiFi On/Off button Pressing this button for two seconds turns the 2.4 GHz and 5 GHz WiFi radios on and off.
with WiFi LED
If this LED is solid white, the WiFi radios are on. If this LED is off, the WiFi radios are turned off and
you cannot use WiFi to connect to the modem router.
For more information, see
WPS button with This button lets you use WPS to join the WiFi network without typing the WiFi password. The WPS
WPS LED LED blinks white during this process and then lights solid white.
For more information, see
For information about turning off the LEDs, see
turn off the LEDs, the Power LED remains on.

Back Panel With Ports, Buttons, and a DC Connector

The back panel of the modem router provides ports, buttons, and a DC power connector.
Figure 2. Modem router back panel
Viewed from left to right, the back panel contains the following components:
• DSL port. One RJ-11 DSL port for connecting the modem router to an ADSL or VDSL line. This port is
colored gray.
Note Use either the DSL port or the Internet port for WAN connectivity.
• USB port. One USB 2.0 port to connect a storage device.
• Ethernet LAN ports. Four Gigabit Ethernet RJ-45 LAN ports to connect the modem router to LAN
devices. These ports are colored yellow.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the modem router to a cable modem.
This port is colored red.
Note Use either the Internet port or the DSL port for WAN connectivity.
AC1200 WiFi VDSL/ADSL Modem Router Model D6220
Control the WiFi Radios
Use WPS to Add a Device to the WiFi Network
Hardware Overview of the Modem Router
on page 100 and
Disable LED Blinking or Turn Off LEDs
12
WiFi LED Is Off on page 253.
on page 94.
on page 200. If you