Trimming Clips; Mapping Keyboard Shortcuts - Blackmagicdesign HyperDeck Installation And Operation Manual

Trimming Clips

When editing clips you'll want to trim them to include only the specific actions you want in each
shot. There are various ways, but the easiest is to adjust the clips' in and out points on
the timeline:
1 After adding clips to your timeline, hover your mouse pointer over the start of a clip until
the pointer becomes a 'trim' icon.
2 When the 'trim' icon appears, click on the start of your clip and drag it forwards or
backwards to trim the in point. Watch the timeline monitor as you trim to find the
edit point.
3 Now click and drag the end of your clip to adjust the out point.
The zoom slider is located above the timeline, to the right of the tools that are centered in the
toolbar. By dragging the slider left and right you can zoom in and out of your timeline to make
fine adjustments.
Turning the 'snapping' feature off is handy when fine tuning edits, but it's a helpful feature to
keep your clips held tightly against each other, so it's worth turning back on once you're done.
Press the 'N' key to quickly turn snapping on or off.
The 'edit' page. You can trim your clips, change their order, move them
around and add transitions between them using the timeline editor.

Mapping Keyboard Shortcuts

If you are familiar with keyboard shortcuts using other editing software, you can easily map your
own in DaVinci Resolve to increase speed and optimise your workflow.
To map your own keyboard shortcuts:
1 Click on the project setting 'gear' icon at the bottom right of your DaVinci workspace,
then select 'keyboard mapping' from the settings list.
2 Select the shortcut you want to change from the categories provided, for example
timeline cut and paste shortcuts will be in the 'edit' category.
3 Click on the shortcut once to highlight the setting. Double click on the shortcut to
enable the change.
Using DaVinci Resolve 33