Switching On The Display; Checking The Battery Capacity; Selection And Activation Of User Functions - Uwatec Smart 2 Operating Manual

2 Operation

2.3 Switching on the display

CNS O
DECO STOP
LEVELSTOP
NO STOP
%
%
NO
CNS O %
2
%

2.4 Checking the battery capacity

Battery capacity

2.5 Selection and activation of user functions

Gauge mode ->26
Input microbubble level ->30
Input O
Logbook ->35
Dive planner ->33
10
• automatically, on submerging in water or when adaptation to atmospheric
pressure is necessary;
• manually, by bridging contacts on housing (B-E).
• When Smart Z is in state of rest no information is displayed
but the atmospheric pressure is continuously monitored. If
a higher altitude range is detected, Smart Z switches on for
NO
NO
3 minutes automatically -> 25.
%
2
• Smart Z switches on by bridging the contacts B and E. All
segments light up for 5 seconds.
Afterwards the display shows the selected O
temperature and in certain circumstances an altitude range
Temperature
->25.
O Mix
2
If the transmitter is switched on and located within trans-
mitting distance, the tank pressure is displayed, otherwise
"---" will be displayed. If no transmitter has been paired yet,
Do not fly icon
the display will be blank.
No-fly time
If there is a remaining saturation due to the last dive or
Oxygen toxicity
change of altitude, Smart Z also displays the remaining
desaturation time, the oxygen toxicity and the "no-fly time"
Desaturation time
->24.
After switching on Smart Z you can check the battery capacity by bridging
the contacts B and E. The remaining capacity is displayed for 3 seconds as
a percentage. If the value reaches 0%, the battery warning gets activated
(->17) and the battery has to be replaced by an authorised SCUBAPRO UWATEC
dealer.
For a 7-day diving vacation Smart Z uses between 2 – 5 % of its battery capacity.
At the surface you can select the dive planner, the logbook
and gauge mode as well as the functions to enter the O
mix and the microbubble levels by bridging the contacts
mix ->18
2
+ and B or – and B.
After the selection of the desired function you can activate and deactivate it by
bridging the contacts B and E.
Details to the user functions are to be found on the pages mentioned above.
mix, the
2
%
2
UWATEC Smart dive computers
®