Table of Contents
Advertisement
REMOTE CONTROL BATTERIES INSTALLATION
Remove battery
1
compartment lid.
Pull up lid and
remove it.
To insure safe operation, please observe following precautions :
● Use (2) AA or LR6 type alkaline batteries.
● Replace two batteries at same time.
● Do not use a new battery with an used battery.
● Avoid contact with water or liquid.
● Do not expose Remote Control Unit to moisture, or heat.
● Do not drop Remote Control Unit.
● If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
● Danger of explosion if battery is incorrectly replaced.
● Dispose of used batteries according to batteries manufacturers instructions and local rules.
Operating Range
Point Remote Control Unit toward
projector (Infrared Remote Receiver)
whenever pressing any button.
Maximum operating range for Remote
Control Unit is about 16.4' (5m) and
60° in front and rear of a projector.
Slide batteries into
2
compartment.
Two AA size batteries
For correct polarity (+ and
–),
be
terminals are in contact
with pins in compartment.
60°
16.4'
(5 m)
16.4'
(5 m)
60°
- 11 -
Replace compartment lid.
3
sure
battery
Advertisement
Table of Contents
