Disassembly Of The Continuous Feed Chute Parts - Waring VCM1000SK Instruction Manual

• Place the slinger (or ejector disc) in the bowl, sliding it over the metal motor
shaft until it reaches the bottom of the chute.
• Select the appropriate CE listed accessory disc: Grating disc, shredding disc,
slicing disc, waved slicing disc, pulping disc, or julienne/French fry disc.
• Each of these discs has a disc stem. The disc stem fits over the double flat
in the food processor's stainless steel motor shaft. The stem will fit inside
either the clear plastic tube inside the bowl, or the continuous feed chute and
slinger.
• After selecting the appropriate disc, lift the disc by holding the disc firmly
between both hands. Be careful not to grab the blades or scrape your hands
on the shredding/grating nodules.
• Carefully guide the disc stem over the metal shaft so the double flats on the
shaft line up with the matching shape of the disc stem. The disc should easily
drop into place, but if not, then gently rotate until you feel it drop into place.
Be sure it is pushed down as far as it will go. Push on the outside rim only;
never touch the cutting blades.
Do not put any food in the chute before placing the accessory disc onto
the shaft.
• Place the cover on top of the chute. Press down the cover until it is fully
engaged on all sides. Rotate the cover lock mechanism until it latches to the
tab on the continuous feed chute. This will prevent the lid from rising up
during processing.
• Turn the chute and cover together, counterclockwise, until the discharge
chute is in the 3 o'clock position and the locking tabs on the motor base are
engaged in the bowl locking slots on the bowl bottom.
• The interlock tab on the cover will simultaneously slide into the tower safety
interlock slot and engage the magnetic safety interlock switch. The interlock
switch prevents operation of the machine unless the cover is in the proper
position. With this switch engaged, the food processor will operate, if the
power is on and the controls are turned to ON ( ) or PULSE (
NEVER ATTEMPT TO START THE FOOD PROCESSOR WITHOUT THE
CHUTE AND COVER LOCKED INTO POSITION.
Two Pushers for Feed Tube
Pick up the large food pusher and the small food pusher. The large pusher is
for processing larger vegetables. The smaller pusher nests in the larger pusher
and can be used for smaller vegetables, guiding long thin vegetables for more
precise cuts and for jobs like slicing pepperoni.
DISASSEMBLY OF CONTINUOUS FEED CHUTE PARTS –
ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING.
• Turn the chute and cover clockwise until the safety interlock tab on the cover
is disengaged from the magnetic safety interlock switch in the tower, and the
6
).