ALORAIR ARMORED 170L Installation And Operation Manual

ALORAIR ARMORED 170L Installation And Operation Manual

Advertisement

Quick Links

Registrate by scanning
Armored 170L
Add: North Carolina USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ARMORED 170L and is the answer not in the manual?

Questions and answers

Summary of Contents for ALORAIR ARMORED 170L

  • Page 1 Registrate by scanning Armored 170L Add: North Carolina USA...
  • Page 2: Installation

    ※Introduction※ please: C ontact your installing contractor The Armored 170L dehumidifier has been introduced to serve the demands of medium- E-mail: sales@alorair.com sized areas without using multiple units. Warehouses, factories, offices and other medium- scale facilities with ambient temperatures ranging from 0.5°C where occur humidity and Installation: condensation problems can been handled efficiently and automatically.
  • Page 3: Front View

    DEHUMIDIFIERS DEHUMIDIFIERS ※Unit Overview※ ※ Front View ※ Rear View Front cover Air Outake Air Outake Rear cover Control Panel Air Intake Side Cover Filter Drain Tube Connection Hand Dug Hand Dug Wheel Wheel...
  • Page 4: Lamp Operation

    DEHUMIDIFIERS DEHUMIDIFIERS ※Operating instructions※ ※Lamp operation ( )Running lights : After power- beep is heard, the machine into standby mode, and this does not light , turned on, the lights lit , after the shutdown , the lights off . ( Note: The standby display digital display profit or humidity ) (2)Continuous running lights : In continuous mode , the lights lit , the other states , LCD Monitor...
  • Page 5: Maintenance And Repair

    DEHUMIDIFIERS DEHUMIDIFIERS B.This machine uses a value consistent with the nameplate power outlet must be grounded port. 2 ."Up" and "Down" Button C. Remove the power cord and reliably , securely plugged into a power outlet. Used to adjust the set humidity , also used to adjust the timing shutdown and timing for D.
  • Page 6: Troubleshooting

    DEHUMIDIFIERS DEHUMIDIFIERS ※ Troubleshooting ※ Clean the filter method : 1.Remove the filter,Filiter may be cleaned by Vacumming or By washing with warm water(no soap or Solvents),Insure cause Trouble Solution Fliter is dry prior to Restarting unit Check Power Supply Display Blank.
  • Page 7: Warranty

    ALORAIR shall not be responsible for loss of use of any product, loss of time, inconvenience, or damage to other equipment, or any other indirect or consequential damage with respect to property whether as a result of breach of warranty, neglect, or other wise.

Table of Contents