Table of Contents
Advertisement
Stratagy DK
Remote Connection
Portable/Desktop Computer Modem
➤
CAUTION!
Stratagy Modem
The Stratagy DK can communicate through either an internal or external modem.
Internal
The Stratagy DK has an internal modem that communicates at up to 2400 baud. No
additional equipment is necessary. (See
on Page1-29
H
External
An external modem can be installed on the Stratagy DK for a communication speed of 9600
baud. If 9600 baud communication is desired:
1.
Note
2.
Step 8:
Load Stratagy Admin Software (VSA.2N or higher)
1.
Note
2.
1-14
Prepare the portable/desktop computer by installing, connecting and configuring a
modem. The modem must be capable of communicating at a minimum of 2400 baud.
COM 1 or 2 only may be used by the portable/desktop computer.
Internal/External modems configured for COM ports 3 or 4 are not
supported by Stratagy Admin software.
for programming information.)
Equip the Stratagy DK with a Hayes-compatible 14400 V32.bis modem. Toshiba's
remote/modem (SG-RMOD) has been tested for consistent operation and is
recommended. Use of other modem models cannot be guaranteed for trouble free
operation.
The default setting configured for the Stratagy DK remote access is serial port 2
(see Figure
1-4). Local and remote access utilise the same designated serial port on
the Stratagy DK.
Connect a telephone line to the modem. Use either a station connected to the telephone
system or a dedicated Exchange line.
Insert disk 1 of 1 of the Stratagy Admin software into the floppy-disk drive of the
portable/desktop computer.
If currently running Windows
this by shutting down Windows and selecting the 'Restart in MS-DOS Mode', or by
using the MS-DOS program or shell.
At the
C:\
prompt type
procedure.
KM
token in
Step 14 "Application Programming"
®
, you will need to obtain a DOS prompt (
a:install c:\admin3
Stratagy DK I&P R2 November 1998
Refer to the Stratagy Library CD-Rom for more details.
Installation
C:\
). Do
to begin the installation
Advertisement
Table of Contents
