Table of Contents
Advertisement
Operating the appliance
en
Starting or interrupting operation
To start operation or to interrupt an operation which has
started running, press the Start/Stop button. The
cooling fan may continue to run after an operation is
interrupted.
Press the On/Off button to delete all settings.
If you open the cooking compartment door during
operation, operation is interrupted. Close the cooking
compartment door to continue operation.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 17
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Fill the water tank before each use:
Open the appliance door.
1.
Remove the water tank from the water tank recess
2.
(picture
).
!
Fill the water tank with cold water up to the "max."
3.
mark. (Picture
).
"
Close the tank cover
4.
until you feel it engage.
Insert the filled water tank (picture
5.
Check whether the water tank is pushed in flush with
6.
the water tank recess (picture
Close the appliance
7.
door.
The water tank has been filled. You can now start the
operation.
12
).
#
).
$
Refilling the water tank
If the water tank is empty, the prompt to fill the water
tank appears on the display. The operation is stopped.
Carefully open the appliance door.
1.
Remove the water tank and fill it.
2.
Slide the water tank back in and close the appliance
3.
door.
Start the operation.
4.
The operation continues.
Setting the heating type and temperature
After the appliance is switched on, the suggested
heating type appears with the temperature. You can
start this setting immediately with the Start/Stop button.
For other settings, you can change the values as shown
in the pictures.
Example: 15 minutes steaming at 90 °C
Use the rotary selector to change the heating type.
1.
Press the arrow ¿ to switch to the temperature.
2.
Use the rotary selector to change the temperature.
3.
Switch to the cooking time using the 0 button.
4.
Use the rotary selector to change the cooking time.
5.
Press the Start/Stop button.
6.
The set heating type, temperature and cooking time are
shown in the display.
Advertisement
Table of Contents
