System Feature Descriptions - Samsung iDCS500 Manual

SYSTEM FEATURE DESCRIPTIONS

Account Code Entry
Station users may enter an account code (maximum 12 digits) before hanging up from a call. This
account code will appear in the SMDR printout for that call record. Keyset users may enter this code
using an account code key without interrupting a conversation. Single line telephone users must
temporarily interrupt the call by hook-flashing and dialing the feature access code. Manually
entered account codes can be up to 12 digits long. In some cases users can be forced to enter an
account code and this account code may or may not be verified as described below.
Forced – – – – Verified Forced Verified
Forced Forced Verified Verified
When set for this option the user must enter an account code for all outgoing calls. The account code
entered will be verified from a system list of 500 entries for iDCS-M and from a list of 999 entries for
iDCS-L version software. Forced Verified codes can contain the digits 0~9.
Forced - Not Verified Forced - Not Verified Forced - Not Verified Forced - Not Verified
When set for this option the user must enter an account code for all outgoing calls, but the account
code is not verified against the system list. Non verified account codes can contain the digits 0~9 and
#.
Voluntary Voluntary Voluntary Voluntary
In this case account codes are not required to make outgoing calls but may be used if desired. This is
also the method used to assign an account code to incoming calls. These account codes can contain
the digits 0~9 and #.
Account Code Key (M Version)
The account code (ACCT) key can be programmed on any keyset and will appear as a soft key on
display keysets. This key allows the user to enter account codes without interrupting a call.
Account Code Key - One Touch (L Version)
The account code (ACC) key can be programmed on any keyset. This key can be programmed with
an extender and operates in three different ways depending on the extender as follows.
Extender = 000
manner as the ACCT key in the M version. That is to say the user will be prompted to enter an
account code when the key is pressed.
Extender = 001~999
when pressed, automatically insert the account code contained in that bin of the system account code
list. This is known as One Touch account codes. This option can be denied in system programming
to prevent users from bypassing the security of system account codes.
No Extender
to enter the bin number the system account code table where the account codes are stored.
All Call Voice Page
Users can page all internal and all external paging zones at the same time by dialing the All Page code.
Keysets may be restricted from making or receiving pages in system programming. A maximum of
99 keysets can be programmed in each internal page zone to receive page announcements.
When programmed with an extender of 000 the ACC key will operate in the same
When programmed with an extender ranging from 001 to 999 the key will,
When programmed without an extender the key will, when pressed, prompt the user
4-3