F6" - Automatic Zero At Start-Up (*) - BIS ASGPP User Manual

"F6" - AUTOMATIC ZERO AT START-UP (*)

Trough this step one sets the weight percentage for the automatic acquisition of the gross zero at start-up. If at the
start-up a weight is detected that is within the programmes percentage of the total capacity, it will be cleared; if the weight
is not within this tolerance, the display, after a few instants, shows the current weight.
Press M+ to select one of the suggested percentages: from 0 to 20.
"F7" - MANUAL ZERO RANGE (*)
Trough this step one sets the weight percentage for the manually acquiring the gross zero; if, in the normal weighing
phase, by pressing ZERO, a weight within the programmed percentage of the total capacity, it will be cleared.
Press M+ to select one of the suggested percentages: from 0 to 20.
"F8" - LIMITATION OF THE TARE FUNCTIONS (*)
on limitation disabled
oFF limitation enabled
Refers to the 6.3.1 section for the functioning mode.
"F9" - A/D CONVERTER POINTS
By pressing TARE the instrument shows the A/D converter points relative to the weight on the scale.
By pressing ZERO one zero the value.
Press TARE to exit the step.
"F10" - SPEED SETTING ADC CONVERTER READING SPEED
By pressing TARE one sets the reading speed of the ADC converter; the set value corresponds to the number of
readings made in a second.
Press M+ to select one of the suggested reading speeds: 7.5, 15, 30, 60.
"F11" - BAUD RATE
By pressing TARE one selects the baud rate.
Press M+ to select one of the possible speeds: 2400, 4800, 9600, 19200.
"F12" - MINIMUM AMOUNT DIVISION
By pressing TARE one selects the minimum amount division.
Press M+ to select one of the suggested values: 1, 2, 5, 10.
"F13" - PRINTER (*)
off disabled
on enabled
"F14" - PRICE INTRODUCTION MODE
FLoAt introduction with floating decimal point
FiXEd introduction with fixed decimal point
"F15" - PRINTING LANGUAGE AND CURRENCY SYMBOL
By pressing TARE one selects the printing language.
Press M+ to select one of the suggested values: En, it, ES, Fr, DE.
By confirming with TARE one sets the text or the symbol of the currency to be printed.
Press M+ to select
- TEXT: Confirm with TARE, insert the text of the CURRENCY on 3 characters and confirm with TARE.
- SYMBOL: Confirm with TARE, enter the ASCII decimal code of the CURRENCY on 3 digits (€=254) and press
TARE.
15